Start the engine and check for leaks around the transmission pan. Lower the vehicle to the ground.Īdd Dexron III transmission fluid or equivalent through the transmission dipstick tube to the proper level as indicated by the dipstick. Raise the vehicle with a jack and remove the jack stands. Install the shift cable bracket and bolts onto the transmission. Tighten the pan bolts to 12 foot-pounds with a 3/8-inch torque wrench. Lift the pan into place against the transmission and install the pan bolts. Place the new transmission pan gasket onto the pan. Slide the new filter into the port and seal until it bottoms out on the transmission.
Insert the seal into the transmission port. Remove any gasket material or residue from the pan.Īpply a layer of Transjel or equivalent to the new filter seal. Wipe the gasket surfaces and the pan interior with a clean shop rag. Scrape the pan gasket from the pan and the pan's mount surface on the transmission with a gasket scraper. Remove the filter gasket from the filter port with a finger or ratchet handle, if necessary. Ensure that the filter gasket was removed with the filter. Pull the transmission filter down and out of the transmission by hand. Pour the remaining fluid into the catch pan. the problem: 4l80e tranny sometimes slips out of overdive then shifts hard after coming to a stop and taking off.
Remove the remaining bolts by hand and lower the pan away from the transmission. Where is the manual transmission fill plug on a 1993 ford escort wagon I have a 2000 chevy crewcab 4x4 3/4 ton old body style. Knock the pan loose from the transmission gently, allowing it to drop slightly and drain into the catch pan. Use caution to avoid deforming the pan body and the pan mounting flange. Tap lightly sideways on the transmission pan with a rubber hammer. Loosen the rear pan bolts about four turns with a wrench. Remove the front and side transmission oil pan bolts with a wrench. Place a catch pan under the transmission pan. Pull the shift cable bracket off of the transmission. Remove the transmission shift cable bracket bolts with a wrench.